3D mixer operating points and buying tips

Three-dimensional mixers With the development of pharmaceutical, food, chemical, metallurgical light industry and other industries, the application of three-dimensional mixers in these industries is also more, mainly for the mixing of new materials, suitable for powdery or better fluidity. Mixing of particulate materials. Things to be aware of during operation
The joint parts of the three-dimensional mixer equipment should be fastened and reliable. The electrical wiring is normal and the connector is not loose or falling off. Reduce the amount of lubricating oil in the reducer, and add lubricant to the chain. Pulling the pulley device is flexible and free. There should be no stuck. The manual filling is carried out according to the nominal volume of 80%. After the material is finished, the feed port cover is closed.
The above points must be paid attention to during the operation to ensure the personal safety of the staff. Proper use of 3D mixers to extend the life of 3D mixers.
Before starting the machine, the operator of the three-dimensional mixer equipment is required to leave the mixing tank one meter away, so as to avoid the injured body in the moving cylinder. Start the main motor and observe the smoothness of the cylinder movement. Start the run button and adjust the mixing time to follow the time. If the time control is not needed, the knob below the time relay moves to the continuous state. The digital display shows that the speed must not exceed 500 rpm. When the person stands in front of the cylinder, the front main shaft turns clockwise and should not be in the direction. After the three-dimensional mixer is mixed, press the stop button, the device stops moving. If the discharge port is not at the lower discharge position, use the electric button to stop the discharge port at the position of the discharge side and open the quick opening cover. Unloading.
There are many ways to choose a 3D mixer. We think we need to pay attention to the following points:
1. Pick the mixer according to the daily production volume. Because the processing time of each batch of material in the mixer is about 6-10 minutes, plus the time of discharging and feeding, the processing time of each batch can be 15 minutes, then 4 materials can be processed in 1 hour. If you choose a mixer with a processing capacity of 10 kg per batch, you can process 40 kg per hour.
2. The mixer is selected according to the nature of the material, such as a mixture of wet and dry materials, and a tank mixer is preferred. The mixing between dry products can be selected from V-type and three-dimensional mixers.

Q-swiched Nd:Yag Laser

Laser Beauty Equipment,Laser Treatment Instrument,Lazer Hair Removal Machine,Tattoo Removal Laser Equipment

Lasy Science & Technology Co., Ltd. , http://www.ywelightmachine.com

Posted on